Best Easy Hot Water Heater

Get hot water where it’s needed, when it’s needed with the Bosch ES4 Tronic 3000 T Electric water heater. This 2.5-gallon capacity point-of-use mini-tank fits right under your sink and provides a practical and effective solution to your hot water needs. This smaller model can be plugged right into a 120-volt outlet with the 36-37″ cord, or can be installed in-line with a larger hot water source to provide “on-demand” use. The glass-lined tank offers great insulation and added durability, while the heater’s fast recovery rate eliminates long waits for hot water. An external dial allows you to easily control the temperature range, and the temperature-and-pressure relief valve enhances your safety. The ES4 Tronic 3000 T from Bosch has a sleek and attractive exterior design that blends in seamlessly with existing décor when installed in a visible location, making this heater a great option in any room.

EASY TO USE
⊙ Attach the 3/4″ GHT garden hose adapter to the fitting marked “water input” and the shower head to the “Water Outlet”
⊙ Install gas supply line and regulator to the portable tankless water heater and attach gas regulator with hose to the LP cylinder
⊙ Install two “D” cell batteries with correct direction and turn on water supply
⊙ Turn your water output device to its “off” position while the gas valve on the cylinder all the way open
⊙ Set the water knob(blue one) to its highest setting(left position) and the gas knob(red one) to its minimum setting(left position)
⊙ Turn on your water output device to the “on” position and adjust to the desired water flow
⊙ Open the drain valve to ensure draining of water upon completion of use or storage and turn off your gas supply
PRECAUTIONS
⊙ When install the water heater please do not over tighten the connectors and pipes to prevent it from bursting and leaking
⊙ The exhaust and top will get hot, please check around area for flammables, especially gasoline or other vapors which may ignite. Please make sure there are no foreign objects around the portable tankless water heater or have fallen into the top
⊙ Please use only liquid propane as fuel and use it in a well-ventilated place.If you want to install indoors, use a pipe to cover the vent hole to ensure that the gas can be led to the outside
⊙ Please make sure there is enough water pressure. If the water pressure is below 2.5 PSI, the water heater cannot be ignited
⊙ If the outside temperature is around or below freezing(0℃/32℉), please ensure to drain out the water after each use to avoid internal damage to the heat exchanger
⊙ Water heater is not suitable for high altitude areas over 3300 feet and strong wind conditions
LIST
1 x 1.58GPM portable gas hot water system
1 x instruction manual
1 x 5 feet CSA regulator
1 x gas inlet connector
1 x shower head set

Product Description

The Bosch US7 Tronic 3000 electric tankless water heater is designed to provide an endless supply of hot water to kitchen, bathroom, and handwashing sinks. This 7.2 kW electric heater eliminates long waits for hot water by using a dual chambered copper heat exchanger. The unit runs at 98% thermal efficiency, so stand-by loss is therefore minimal. Plus, it mounts on the wall in any direction and is compact and lightweight, making it a great choice for a variety of spaces. This item requires professional installation and hardwiring. With its top performance specifications and versatility, the US7 Tronic 3000 is a great way to get the hot water going in kitchens, offices, at warehouses, service stations, stores, and concession stands.

From the Manufacturer

Ultra compact and lightweight, these five point-of-use / under-sink tankless water heaters were designed to provide an endless supply of hot water for 1 kitchen and / or bathroom sink at a time in commercial, industrial, and residential applications. Advantages include 98 % efficiency with minimal stand-by loss. Most models come equipped with high / low kW settings and universal horizontal / vertical mounting options.

Product Description

This Smart Technology electric tankless water heater is configured as a “whole home” model for climates where incoming water temperature is 62°F and above. The ECO 18 is capable of heating over 2.5 gallons per minute, which is the equivalent of one water saver shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 62°F, and an output setting of 105° F. Two showers emitting no more than 1.5 gpm each can be run simultaneously when incoming water temperature is above 70° F. Digital temperature control allows you to set your temperature in increments of 1°. All tankless water heaters are sized based on flow rate and temperature rise, and there is a direct relationship between the two. So if used in a cold area requiring a high temperature rise, it will be more limited in the amount of fixtures (gallons per minute) it can heat at one time compared to a warmer climate. However, when sized properly it will provide endless hot water and only consume the energy needed, giving the user complete control. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The ECO 18 requires a minimum 150 amp electrical panel for installation with (2) 40 amp double pole breakers connected to (2) sets of #8 awg wire. Plumbing connections are 3/4″ NPT. For additional assistance please feel free to contact our support center at 877-474-6473.

From the Manufacturer

This Smart Technology electric tankless water heater is configured for climates where incoming water temperature is 62 Degree F and above. The ECO 18 is capable of heating over 2.5-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 62 Degree F. Two showers can be run simultaneously when incoming water temperature is above 70 Degree F in warmer climates such as South Texas, South Florida, New Mexico, Arizona and South California. These models come with a digital temperature control that allows you to set your temperature in increments of 1 Degree. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

Features:
This is a water heater for the application of changing the cold water into hot water and it will meet your various needs such as used in kitchen, bath room, public restroom, etc. It is a high efficient water heater with compact size to produce the hot water very quickly. LCD digital temperature display.
Freely adjust water temperature by water flow, simple operation. Safe heater, electricity saving, water saving, no pollution, no exhaust gas. Stainless construction with mini design, it is durable, elegant and fashionable.
Specifications:
Material: Stainless Steel Shell
Color: Golden, Red(optional)
Power: 3000W
Current: 13A

Voltage: 110 V

Rated Frequency: 50Hz

Rated Pressure: 0.04-0.4Mpa

Temperature: 30-45℃(Considering the use environment in severe cold areas may not reach the maximum temperature of 45℃)

Installation wire diameter: ≥2.5mm² copper wire
Water pipe interface: G 1/2″ interface

Size: 16 x 13.5 x 6.5cm / 7.87 x 4.13inch (appr.)

Package Included:
1 x Water Heater
2 x Fixing Screws

2 x Screws Protector

1 x Manual

Note:
1. Please note this item should get the water first and then link the electricity when installing.
2. You’d better install this item vertically to ensure long service time.
3. Please kindly make a note if you need any adapter.
4. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.

Product Specifications:
Power: 3000W
Plug: 10A
Voltage: 110V
Rated frequency: 50/60Hz
Rated pressure: 0.4-0.6Mpa
Waterproof rating: IPX4
Temperature: 30-45 degrees Celsius
Material: stainless steel housing
Interface: International 4 points caliber
Color: black, gold, red, white (optional)
Size: approx. 20 x 10.5cm / 7.87”x 4.13”
Package weight: approx. 1142 g / 40.28 g

Package Included:
Electric water heater *1
Instruction manual*1
Screw *2

Note:
1.Please note that this project should first take water and then connect the power supply during installation.
2.You should install this project vertically to ensure a long service time.

Conclusion

By our suggestions above, we hope that you can found easy hot water heater for you.Please don’t forget to share your experience by comment in this post. Thank you!