The 6 Best Computer Water Cooling Temp And Flow Meter

Specifications:
Monitoring Range: -50 ~110 degrees
Voltage: 5V – 24V
Interface: Big 4P
Screw Thread: G1/4
Upper Panel Size: Approx. 4 * 8cm
Flat Plate Size: 4 cm * 8 cm
Applicable Pipe: 9mm Outer Diameter
Thermometer Panel Size: Approx. 47.8 * 28.2mm
Package Size: Approx. 12 * 9 * 3cm
Weight: 98g
 
Package List:
1 * Water Flow Meter
1 * Thermometer
2 * Connectors
2 * Clamps
 
Note:
●Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same.
●Product’s size made for manual measurement,  1-2CM error belongs to the normal range.

Water Cooling Acrylic 2 Way Meter G1/4 Threaded without Barbs.
100% new, fine workmanship, simple sense is very strong!
Collocation two pieces of G1/4 thread connector, suitable for 3/8 ID, 1/2 OD pipe(Not Included here).
2-way configuration, you can Installation drain port, temperature probe, LED lights and so on.
Available colors are :Red,Green.
Package includes:1 x Water Cooling Meter.

The new temperature sensor from Phobya with g1/4″ inner thread and G1/4″ outer thread respectively. With its compact design this sensor can be integrated into the cooling loop at virtually any suitable thread. Its timeless design makes it blend right into the system, especially as it’s low height of only 11,6mm (without threads) allows it to fit below almost any connector. The sensor cable is equipped with a standard 2-Pin plug. High-Flow, no narrowing of the cooling channel inside of the sensor! Also see example of installation. This cable is not only practical, it is also optically appealing, The surrounding mesh, also called mesh, which is surrounding the cable itself offers the advantages that every Pro-modder is looking for: A completely unique look, even of the cables in the system! Special attention was paid to the combination of cable connectors, sleeve and heatshrink which were used to ensure great design and a unique as well as elegant look.

Model: 71227

EK-PLUG G1/4 Acetal – Black (10 pack) is a simple pack of ten black acetal G1/4″ plugs with o-rings. The plugs can be easily tightened with a one Euro coin or a similar sized coin. The set of plugs is useful to cap your liquid cooling hardware which you are storing for a longer period of time. The simple acetal plug will prevent dust setting into your liquid cooling gear and since its an airtight plug, it will also prevent oxidation.

This set can also be utilized to convert EK-RES X3 Series reservoirs (also X4), EK-D5 Series pump combo units and EK-DDC Series pump combo units to be compatible with EK Fluid Gaming aluminum parts, by swapping out the brass nickel plated plugs.

Made from black CNC machined acetal. Sealed with quality o-rings.

Technical data:

– Threading: G 1/4″
– Thread length: 4mm
– Diameter: 17mm
– Height: 2.7mm

Model: 3830046995735

Inline filter with replaceable stainless steel mesh. Supplied with replacement mesh filter and two replacement o-rings.

Model: 5060596650343

This temperature sensor is equipped with a G1/4″ inner- and a G1/4″ outer thread and can therefore be integrated easily even directly on a waterblock or radiator. The sensor is equipped with a 60cm long cable and has a two-pin plug for connection.

Model: 53067

Conclusion

By our suggestions above, we hope that you can found computer water cooling temp and flow meter for you.Please don’t forget to share your experience by comment in this post. Thank you!